Features
- Flush mounts over a
single-gang box
- Alarm: 25% LEL
methane and propane
- UL Listed, CSFM
Approved
- Flush or Surface
Mount
- Alarm and Trouble
Relays
- 7-10 year Sensor
Applications
Homes, offices,
schools, businesses,
hotels and other
commercial
environments
Area: 900 ft2 (84 m2)
Simple.
- Easy Operation: A green LED signifies that the GD-2A is armed. If gas is detected, the red LED flashes and the alarm condition is activated.
- Quick Installation: Three part plastic case allows for easy surface mount installation or near flush mount over a four-inch square or double gang electrical box.
- Maintenance Free: The GD-2A uses a self-purging semi-conductor electronic sensor which requires no maintenance or recalibration.
Trusted
- Self-Restoring or Latching Functionality: Allows installer to choose whether GD-2A will switch back to normal state after air clears of gas, or stay in alarm until power is interrupted.
- SPDT Alarm and SPST Trouble Relays: Designed for seamless connection to control panels or other devices.
- Temperature Compensated: For accuracy over the entire operating range.
Certified
- Time-Honored Quality: Backed by Macurco’s reliable brand quality and 3M’s history of customer dedication and satisfaction.
- Listed to UL Standard 2075 for the standard for safety for gas and vapor detector and sensors.
- Sensitivity Tested based on UL 1484 Standard for Residential Gas Detectors.
Power Information
- Operates on DC or AC voltages between 12 and 24 volts.
- Utilizes a full wave bridge rectifier at its power input so that it is independent of the polarity of the input power.
- Switching regulator is used to efficiently match the wide input voltage range to the fixed, internal power system.
Visual Display
- Green LED light blinks on and off during the warm up period.
- Continuous green light (ARMED) indicates normal operation.
- Both lights flash on and off when a trouble condition occurs.
- Red LED (ALARM) turns on at the same time the SPDT alarm relay activates to indicate the alarm condition.
Advanced Relay Features
- Self-restoring operation turns off red light when air clears of gas, switching to normal state.
- Jumper wire on circuit board can be clipped to allow unit to latch in upon alarm. Power will then need to be interrupted to unlatch alarm condition.
Requirements
- Designed for connection to UL Listed Fire Alarm/Burglary Control Panels. Do not connect the GD-2A to Fire Alarm Circuits, or Burglar Alarm or other signals.
- Alarm Control Panel must be dedicated to gas detection or have alarm devices that provide a distinctive alarm for gas detection.
- Intended for installation in buildings in non-hazardous locations such as residences, retail stores and office buildings.
Easy to install, simple to operate and engineered for reliability. The GD-2A is the professional
choice for heating type gas detection.